Troubleshooting; Product Maintenance - HAMPTON BAY 680-068 Manual De Instrucciones

TROUBLE SHOOTING:
Problem
Light Bulb will not illuminate.
Fuse blows or circuit breaker
trips when light bulb is
illuminated.

PRODUCT MAINTENANCE:

1. To clean the fixture, first disconnect power to the fixture by turning off the circuit
breaker or by removing the fuse at the fuse box.
2. Use a dry or slightly dampened clean cloth (use clean water, never use a solvent)
to wipe the interior and exterior surfaces of the fixture.
3. Allow the fixture to dry thoroughly before power is restored.
CAUTION: Do not use chemical solvents or harsh abrasives to clean fixture as damage
to the fixture or various components may occur remedying the fixture inoperable.
The manufacturer warrants this lighting fixture to be free from defects in materials and
workmanship for a period of five (5) years from date of purchase. This warranty applies
only to the original consumer purchaser and only to products used in normal use and
service. If this product is found to be defective, the manufacturer's only obligation, and
your exclusive remedy, is the repair or replacement of the product at the manufacturer's
discretion, provided that the product has not been damaged through misuse, abuse,
accident, modifications, alterations, neglect or mishandling. This warranty shall not apply
to any product that is found to have been improperly installed, set-up, or used in any way
not in accordance with the instructions supplied with the product. This warranty shall not
apply to a failure of the product as a result of an accident, misuse, abuse, negligence,
alteration, or faulty installation, or any other failure not relating to faulty material or
workmanship. This warranty shall not apply to the finish on any portion of the product,
such as surface and/or weathering, as this is considered normal wear and tear. The
manufacturer does not warrant and specially disclaims any warranty, whether express or
implied, of fitness for a particular purpose, other than the warranty contained herein. The
manufacturer specifically disclaims any liability and shall not be liable for any
consequential or incidental loss or damage, including but not limited to any labor/expense
costs involved in the replacement or repair of said product.
Possible Cause
1. Light bulb is burned out.
2. Power is off.
3. Faulty wire connection.
4. Faulty switch.
Crossed wires or power wire
is grounding out.
LIMITED WARRANTY
4
Corrective Action
1. Replace light bulb.
2. Make sure power supply is
on.
3. Check wiring.
4. Test or replace switch.
Check wire connections.