Machine Set-Up - Amano American Sanders B-2+DC Manual Del Operador

EN
CAUTION:
This machine will operate only on the AC frequency and electrical voltage shown on the nameplate. Make sure you have the
correct frequency and voltage before connecting the power cord to an outlet.
This machine must be connected to the electrical ground to protect the operator from electric shock. The machine has a power cord with two main
conductors and one earthing conductor. Connect the plug to the type of receptacle shown in figure 5. The green and yellow conductor cord is the
ground wire. Never connect this wire to any terminal other than the ground terminal.
WARNING:
Always use this machine with an AC three-conductor electrical system connected to theelectrical ground. Replace any worn,
cut, or damaged cords. Replace any damaged plugs, receptacles, or connector bodies. Do not move the machine over an
electrical cord. Always lift the cord over the machine.
European
Plug
This sanding machine is designed to be operated with a remote
vacuum dust collection sytem or with the included dust bag.
Preparing Remote Vacuum Dust Collection Sytems
To prepare the machine for remote vacuum dust collection systems
that have a 2" hose end, follow this procedure:
1. Install 2" hose end (figure 1, A) directly over the exhaust tube
(figure 1, B).
2. The exhaust tube can be rotated for optimum convenience.
To prepare the machine for remote vacuum dust collection systems
that have a 1 ½" hose end, follow this procedure:
1. Install the 2" x 1½" hose end adaptor (Part No. 30563A)
(figure 1, C) over the exhaust tube (figure 1, B).
2. Insert 1 ½" hose end (figure 1, D) into the adaptor (figure 1, C).
NOTE: Start the remote vacuum collection system before
operation.
Preparing to use the included dust bag
To prepare the machine for use with the included dust bag (Part No.
53544B), follow this procedure:
1. Install the dust bag by pressing the end onto the exhaust tube
until the ring locks into the groove (figure 2). This is best done
by pressing on the back of the bag opening with the palm of
your hand.
2. The exhaust tube can be rotated for optimum convenience.
3. To remove the dust bag from the exhaust tube, pry up the end
of the bag opening to partially release the internal rib from the
groove, then pull.
4. To empty the dust bag, unzip the disposal flap and force
contents out by inverting the bag.
NOTE: For best results, empty frequently. Follow all warnings
posted in this manual and on the dust bag.
Electrical Connection Instructions (230V)
Pin Earthing
Contact

Machine Set-up

Side Earthing
Contact
A
2" Hose from
vacuum system
(not included)
B
Exhaust Tube
C
Install the dust bag by pressing
8
Figure 5
D
1.5" Hose from
vacuum system
(not included)
(30563A) 2"
Tube x 1.5" hose
Figure 1
adaptor
the end onto the exhaust tube
until the ring locks into the
groove.
Figure 2