Operating Instructions; Auto Power Off - Beha-Amprobe VOLTfix Serie Manual De Instrucciones

• Identifies polarity (line vs. neutral) of receptacles
and cables. (Depending of the internal
construction and dimension of receptacles in
different countries this application may be
influenced.)
• Tests voltage without contact.
• Safety CAT IV 1000 V rated for a wide range of
applications including industrial, commerical,
and residential.
• Water-resistant IP65 rated for indoor and
outdoor use.
• Magnetic solenoid detection to diagnose
electromagnets and relays
(NCV-1040-EUR MAGNO-VOLTfix only).

OPERATING INSTRUCTIONS

Turning the Voltage Probe ON
To turn the Voltage Probe on, momentarily press
the ON/OFF button. A continual single flash
visually indicates the Voltage Probe is active in
default voltage range (50 to 1000 V). Press the
ON/OFF button
sensitivity range (12 to 50 V for NCV-1030/1040-EUR
(MAGNO-)VOLTfix only). A continual double flash
indicates the Voltage Probe's sensitivity range is at
the 12 to 50 V range.
Turning the Voltage Probe OFF
Press and hold the ON/OFF button
than two second to turn the Voltage Probe off. The
absence of flash at the tip indicates the Voltage
Probe is inactive.

Auto Power Off

To save battery life, the NCV-1030/1040-EUR
(MAGNO-)VOLTfix are enabled with an automatic
power off feature. The Voltage Probe will
automatically power off after approximately 3
minutes of non-use.
Checking for the Presence of AC Voltage
To test for the presence of AC voltage in a
receptacle, insert the tip of the Voltage Probe. To
test a wire, approach the wire with the tip of the
Voltage Probe. Switch between default (50 V to
1000 V AC) and high sensitivity (12 V to 50 V AC)
voltage range detection by short pressing the ON/
OFF button (NCV-1030/1040-EUR (MAGNO-)VOLTfix
only). The LED at the tip of the Voltage Probe will
illuminate and flash bright red and a buzzer will
sound when AC voltage is detected.
again to switch to high
4
for longer