Technical Data; Installation; Mounting - Henkel Loctite Shot Miser Manual De Operación

3. Technical Data

Loctite ® Shot Miser™ Dispense Valve 98085
Pneumatic Supply
Quality
Control Air Connection
Compressed Air Usage
Product Pressure
Product feed line
Weight (less tubing & dispense needle) 228 grams (0.5 lbs.)
Loctite ® Shot Miser™ Valve Controller 98079
Input Voltage / Cycles
Fuse
Size (width x depth x height)
Weight
Loctite ® 1 Liter Shot Miser™ Reservoir 98090
Pneumatic Supply
Size (width x depth x height)
Weight

4. Installation

Caution!
DO NOT REMOVE ANY ITEMS THAT ARE SEALED IN PLASTIC BAGS UNTIL THEY ARE TO
BE USED AS THEY MAY BECOME CONTAMINATED, RESULTING IN PERFORMANCE
PROBLEMS.

4.1 Mounting

Secure Loctite ® Shot Miser™ Dispense Valve (Part no. 98085) to a mounting surface with #10
dia. or 5 mm dia. screws. The hole pattern is given in Figure 2. Tighten the mounting screws to
approximately 10-inch pound torque.
Loctite ® 1 Liter Shot Miser™ Reservoir 98090
Notice:
• Always use wire stand to support the reservoir.
• Never pour product directly into the reservoir
min. 30 psig, max. 70 psig
filtered to 10 µm, oil free, non-condensing
4 mm (.157")
less than 1 scfm per stroke.
0 psig to 80 psig
6.3 mm (.250")
115 VAC, 50/60 Hz
1 Amp, 250V, 5 mm X 20 mm, Fast Acting
6.1 inches X 6.9 inches X 3.9 inches
3.5 pounds
100 PSI maximum
8.5 inches X 8.5 inches X 13.25 inches
8.5 pounds
7