Tabla de contenido
Publicidad
4. Instale el software del acelerador de gráficos Sun XVR-100. Escriba:
#
./install
En este caso, aparecerá lo siguiente:
Installing SUNWpfbx.u SUNWpfbcf SUNWpfbw SUNWpfbmn for Solaris 8 ...
Installing required patch 114537-34 ...
*** Installation complete.
To remove this software, use the 'remove' script on this CDROM, or
the following script:
/var/tmp/xvr-100.remove
A log of this installation can be found at:
/var/tmp/xvr-100.install.2005.02.10
To configure a Sun XVR-100 graphics accelerator, use the fbconfig
utility. See the fbconfig(1m) and SUNWpfb_config(1m) manual
pages for more details.
*** IMPORTANT NOTE! ***
This system must be rebooted for the new software to take effect.
Reboot this system as soon as possible using the shutdown command and the
'boot -r' PROM command (see the shutdown(1M) and boot(1M) manual
pages for more details).
Si el software se hubiera instalado anteriormente, aparecerá lo siguiente:
The version is the same on the system. Packages not installed.
All required software is already on the system.
Puede utilizar el siguiente comando para comprobar si el acelerador de gráficos
Sun XVR-100 ya está instalado en el sistema. Escriba:
#
/usr/bin/pkginfo | grep pfb
Capítulo 2 Instalación del hardware y software del acelerador de gráficos Sun XVR-100
13
Publicidad
Tabla de contenido
