Operation Modes; Selecting Mode; Fan Mode - Hisense Y-H1 Manual De Instrucciones

Operation instructions

Operation modes

Each time MODE button is pressed, the operation mode
is changed in sequence:
COOLING DRY
Heating mode is NOT available for cooling only air conditioner.
Each time the "FAN" button is pressed, the fan speed is
changed in sequence:
Auto
At "FAN ONLY" mode, only "High","Medium" and "Low" are available.
At "DRY" mode, Fan speed is set at "Low" automatically, "FAN" button
is ineffective in this case.
Setting temperature
Press once to
Press once to
*HEATING, COOLING
Note: Heating mode is NOT available for cooling only models.
SWING, SMART, TIMER ON, TIMER OFF, CLOCK, SLEEP and SUPER operation modes will be
specified in the following pages.
Changing modes during operation, sometimes the unit does not response at once. Wait 3 minutes.
During heating operation, air flow is not discharged at the beginning. After 2－5 minutes, the air flow will be discharged
until temperature of indoor heat exchanger rises.
Wait 3 minutes before restarting the appliance.

Selecting mode

FAN ONLY

FAN mode

High Medium
raise temperature setting by 1
lower temperature setting by 1
Range of available set temperature
18℃~32℃
HEATING
Low
℃
℃
3
2
MODE CLOCK TIMER ON TIMER OFF
1
SLEEP DIMMER
SWING SMART
SWING MUTE TEP SWITCH
I FEEL SOFT