Axis Q87-E Power Supply 230 Guia De Instalacion página 8

Page 8
4. Connect the pan/tilt power supply to the pan/tilt connector (J4) in the power supply.
5. If using the day/night sensor, connect the illuminator cable to the illuminator connector (J5) in
the power supply.
6. If using the day/night sensor, adjust the potentiometer to increase or decrease the sensitivity of
the day/night sensor. see Day/Night Sensor, on page 9.
Connect the mains supply cable to the mains supply connector in the power supply.
N L
1 2
7. Close the power supply and tighten the lid screws.
8. Screw the cable gland caps on firmly.
AXIS Q87-E 230/120 V AC Installation Guide
F1 F2
J3
J2
J1
L N
TR1 TR2 TR3
3
1 Mains supply connector
2 Main supply cable
3 Pan/tilt connector
4 Pan/tilt power supply cable (24 V AC)
5 Illuminator connector
6 Illuminator cable
7 Potentiometer
L1 L2 K1
J4 J5
TR4 24~ 24~
status
- +
4 5 6
P1
J6
7