Rane MLM82S Guia Del Usuario página 4

Setup
Items not listed under
This section is provided as a convenience for those in a rush. If you are experienced with this unit or
other Rane products, these few words will refresh your memory. Inputs 1-4 may be mic or line-level.
The choice between the two is made by setting the Line push buttons on the rear of the unit next to
the Mic/Line inputs. Each microphone input may be assigned to A, B or A+B outputs using the front
panel Assign switches. Inputs 5-8 are stereo line inputs which may be set to mono using the
recessed Mono switches located on the front panel. Internal switches allow setting output signal
levels for Mic or Line. The factory default setting is Line. If the MLM82S is connected directly to a
power amplifier, equalizer, or recorder input, choose Line. If the MLM82S is connected to a
microphone jack of an existing sound system, choose Mic. Once inputs, outputs, and power are
properly connected, with the Output Levels counter-clockwise (off), set the input levels as high as
possible without causing the Sig/Ol indicators to illuminate. Then slowly raise the output levels as
desired.
Power
Powered
Speakers
4
Introduction > Box Contents
m1
m2
volume
are sold separately.
pitch
Keyboard
Microphones