Using The Camera - AKASO TC04 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

A fixing for a padlock is provided between the two locking brackets, allowing the camera to be
securely locked.
2. Insert batteries
• Open the camera as described in part 6.1 to insert
the batteries. The battery compartment is housed
in the right, rear part of the camera. Now open the
protective cover of the battery compartment by
pulling the clamping closure at the top slightly
inwards before lifting off the cover.
• Insert 8 fully batteries as shown in the below figure. When inserting batteries ensure correct
position as marked for each battery in the battery compartment.
• Close the battery compartment again with the protective cover.
Note:
- Instead of type LR6 (AA) batteries, rechargeable batteries with the same specification (with
2000 mAh or higher) may be used. We recommend NiMh batteries with low self discharge
(not supplied).
- There will be an alarm if battery is low in power.
3. Insert memory card
In order to save photos and videos, you must insert a Micro SD memory card to the slot before
turning on the camera.
If the camera displays "Card protected", remove the memory crd and change the position of
the memory protection.
5
Insert the memory card as shown in the illustration.
Push the memory card into compartment until it
clicks into place.
To remove the memory card push card in again
until it is partly ejected.
Note: Micro SD memory cards up to 32 GB are
supported.
4. External power supply
The camera can be powered with an external power supply
(not included). A 6V power supply (with a connector) ≥1.5 A,
together with a 3.5 mm external and 1.35 mm internal
diameter connector is required.
Note: Rechargeable batteries cannot be recharged in the
camera with an external power supply.
Remove any existing batteries from the battery compartment
when the camera powered with an external power supply.
Install the camera with a strap
Use the incluede securing strap to attach the camera to a tree or other object. The illustrations
below demonstrate how to fasten the securing strap.
Position your camera as desired and pull the loose end of the securing strap tight until the
camera is firmly secured. To release the securing strap again, pull at the tab of the securing strap.

Using the camera

Prior to setting up the camera for surveillance, it must be set up for the respective purpose.
For this purpose, there is a setup mode available. In addition to changing settings, photos
and videos can be taken and existing photos can be viewed in this mode.
6

Publicidad

Tabla de contenido
loading

Tabla de contenido