Emerio PRO KLIMA FN-114501.2 Manual Del Usaurio página 39

PARTS DESCRIPTION
1. Fan head
2. Small screw
3. Tilt adjustment knob
4. Tilt range knob
5. Connecting bolt
6. Height adjustment pipe
7. Height adjustment knob
8. Speed control switch
9. Oscillation knob
10. Standing shaft
11. Standing base
12. Big washer
13. Small washer
14. Base locking screw
ASSEMBLING INSTRUCTIONS
1. Screw off the washers and base locking screw from the standing shaft. Attach the standing shaft onto the
standing base. Place the big washer, small washer and base locking screw. Rotate the base locking screw to
fix the standing shaft firmly.
2. Loosen the height adjustment knob and pull out the height adjustment pipe. Tighten the height adjustment
knob.
3. Place the fan head at the top of the height adjustment pipe. Slide into the connecting bolt. Then at the other
side, use a screwdriver to fix the small screw into the open slot.
4. Under the small screw, rotate and tighten the tilt adjustment knob onto the tip side of the connecting bolt.
5. Above the connecting bolt, fix into tilt range knob. Make sure the fan head is firmly attached onto the height
adjustment pipe.
OPERATING INSTRUCTIONS
1. Plug the power cord into a suitable socket.
2. Oscillation: To make the fan head oscillate, push down the oscillation knob. To stop the fan head from
oscillating, pull up the oscillation knob.
3. Tilting Angle: you can adjust the fan to the preferred elevation by the tilt adjustment knob and tilt range
knob. Tighten the two knobs after the adjustment of tilt angle.
4. The fan is switched on by turning the speed control switch, i.e. O = OFF, I = low Speed, II = medium Speed,
III =high speed.
CLEANING
1. Before servicing the fan and after each occasion of use, switch off the appliance and unplug the mains
cable from the socket.
2. Never immerse the appliance in water (danger of short-circuit). To clean the appliance, only wipe it down
with a damp cloth and dry it carefully. Always take out the mains plug first.
3. Take care that excessive dust does not build up in the air-intake and air-outlet grille, and clean it
occasionally using a dry brush or vacuum cleaner.
TECHNICAL DATA
Operating voltage: 220-240V ~ 50/60Hz
Power consumption: 50W
- 38 - FN-114501.2 / FN-114501.3