Metalux WaveStream Instrucciones De Instalación página 2

Installation Instructions – WaveStream Linear
2. Wire fixture according to code and install channel cover
to channel with provided screws. (Figure 2.)
Channel
Cover
Figure 2.
3. Remove the waveguide assembly from the box and
slide it into the channel assembly.
Figure 3.
4. Secure the waveguide assembly to channel assembly
with screws provided, Figure 4. (One side of the fixture
only) (Use a long bit or right angle tool).
Figure 4.
5. Connect LED wire harness on each end of the
waveguide assembly. (Figure 5.)
Fixture harness
Waveguide assembly harness
Figure 5.
2
COOPER LIGHTING SOLUTIONS
Channel
Channel
Slide
Assembly
Waveguide
assembly
Screw
Installation instruction
IB519017EN
6. To install safety cable remove screw from channel
assembly and reattach safety cable with the same
screw. (Figure 6.)
Screw
Figure 6.
7 . Remove protective film from the waveguide. Remove
endcaps from parts box, install Endcap to fixture.
Tuck wire harnesses and safety cable while installing.
Endcap tabs must fully engage in the metal bracket.
(Figure 7 .)
Endcap
Sheet metal
Bracket in
Waveguide
Figure 7.
Safety
Cable
Endcap Tab