Clicker KLIK1U Manual Del Usaurio página 3

®
CLICKER Models KLIK1U & KLIK1C
Program to Genie ® IntelliCode
BEFORE STARTING:
You MUST have a Genie ® IntelliCode
remote control with at least one button
already programmed to the opener.
®
PROGRAM TO THE GENIE INTELLICODE
5 On the garage door opener,
press and hold the Program/Set
button until both the long and
short LED light up BLUE.
®
9 On the CLICKER remote control, press and
release the same button you have already set
up to control your garage door opener in the
previous section. Both LED's on the garage
door opener will light up PURPLE.
SPCMB01
® 2
SETUP THE CLICKER ® REMOTE CONTROL:
® 2
Remove the front cover
1
of the Clicker ® remote.
®
2 GARAGE DOOR OPENER:
6 Release the Program/Set
button and only the round
LED will be lit in BLUE.
10 On the CLICKER
press and release the same button
again. Both LED's on the garage
door opener will light up BLUE.
Press the program Select a button to program and
2 3
button until the press that button 5 times, ensuring
LED lights. the LED stops
flashing after
each press.
7 Press and release the
Program/Set button and the
long LED will flash PURPLE.
®
remote control, 11 On the CLICKER
same button again. This will activate the garage door opener
and programming is complete.
If the door does not activate, return to Step 1.
© 2011, Clicker Corporation
All Rights Reserved
Press the
4
program button.
8 On the Genie ® remote control, press
and release the button that is already
programmed to the garage door opener.
Both LED's will flash PURPLE.
®
remote control, press and release the
Genie and IntelliCode are trademarks of GMI Holdings, Inc.