Intended Use - Ivoclar digital PrograPrint Cure Guía Breve

2 Safety
WARNING! Improper use of the device.
Hazard to the user.

The safety chapter contains important information on the safety of the device: Please read
it thoroughly prior to installation and operation.
The device is built according to state-of-the-art technology and recognized safety regulations.
Nevertheless, operation bears the risk of injury for the user or third parties. Moreover,
impairments of the device and other property are possible.
2.1

Intended use

PrograPrint Cure has been designed for use in dental technology for curing and post-curing
the following materials:
• Ivoclar Digital PrograPrint materials:
– ProArt Print Wax (burn-out material for the press and casting technique)
– ProArt Print Model (material for the fabrication of the dental working models)
– ProArt Print Splint (material for the fabrication of dental drilling templates and
splints)
• Dental technical, light-curing laboratory composites (e.g. SR Nexco)
• Dental technical, light-curing materials
Use PrograPrint Cure exclusively for this purpose.
In the case of damage caused by improper use or failure to observe the Operating Instructions,
all liability and guarantee claims are void.
Please note that only the materials and cleaning agents approved by the manufacturer ensure
processing without damage to the machine.
All information regarding material and indication extensions corresponds to the state of
knowledge at the time of going to print. For additional details, go to
http://www.ivoclarvivadent.com.
The post-curing of 3D-printing materials from other manufacturers is not recommended due
to the lack of coordination with this procedure.
English
7