MID WEST FERRET NATION 183 Instrucciones De Armado página 2

assembly InstructIons
1.
Remove the Top Panel Grid from the existing cage. Set the Top Panel
Grid aside fo use later.
2.
Locate the Door Panel (A) and insert the pegs into the outer-most
holes of the Base Assembly. The Door Panel should be inserted on
the side of the stand that has the two locking casters. Be sure the
door locking knobs face outward.
3.
Locate the Middle Floor Panel Grid (D) and insert the protruding wires
into the corresponding holes of the Door Panel. Orientate the panel
so the opening is either in the back-right or front left of the cage.
Locate the Back Panel (B) and insert one peg in one of the back, outer-
4.
most holes. Be sure the protruding rectangular openings are facing
inward. While slightly lifting the Middle Floor Panel Grid, swing the
other end of the back panel around, aligning the protruding wires of
the Grid with the holes in the Back Panel. When they are all lined up
and inserted, put the peg in the outer-most hole.
Locate the remaining two Side Panels (C), two Swivel Locks (I), and
two Flat Head Screws (H). Using the Phillips Head Screwdriver (J)
5.
and flat head screws attach one Swivel Lock to each of the Side
Panels. (Do not tighten all the way). Attach the Side Panels by
inserting the pegs into the holes between the Door and Back Panels.
Be sure the cut-outs on the bottom go around the protruding wires of
the Bottom Floor Panel Grid. Insert the protruding tabs at the top of
the panels into the protruding openings in the Door and Back Panels
to lock the panels together.
1
4
3
5
2