Inficon GAS-Mate Manual Del Usuario página 6

Install Two "D" Cell Alkaline Batteries
W A R N I N G
To prevent ignition of a hazardous atmosphere, batteries must only
be changed in an area known to be non-hazardous (i.e., free of
combustible gas).
Use only Duracell
intrinsically safe approval.
1. Remove the battery cover by releasing the latch and sliding the cover down and
off the handle. You may need a small flat-blade screwdriver to assist with
releasing the latch.
2. Install two Duracell
Figure 1 Properly installed alkaline batteries
+
3. Reinstall the battery cover by aligning it in the grooves on the handle and sliding
it up the handle until it latches.
NOTE: If the Battery indicator flashes or if the Battery and highest signal indicator
both flash, the batteries are low and should be replaced.
NOTE: Dispose of depleted alkaline batteries according to applicable state and
local regulations. In the absence of such regulations, recycle and/or
dispose of batteries through voluntary waste recycling programs.
®
MN1300 "D" size batteries to maintain
®
MN1300 "D" size alkaline batteries as shown in
- +
6
-
Figure 1.