Electrical Connection; Intended Conditions Of Use; On/Off Switch; Motor Maintenance - Femi 350 PLUS Instrucciones Para El Uso Y Manutencion/Repuestos

2.4

ELECTRICAL CONNECTION

Check that the mains system in which the machine is
inserted is connected to ground as set forth in the prevailing
safety standards and that the current socket is in good
condition.
The user should not forget that a magnetothermal circuit
breaker must be installed upstream of the mains system
to safeguard all the conductors from short circuits and
overloads.
This protection must be chosen according to the machine's
electrical specifications shown on the motor.
The connecting wires of the suction fan are as follows:
Yellow/green =
Blue =
Brown =
WARNING:
Do not leave the suction fan in the rain and do
not use it in humid places.
The suction fan's motor is rated to operate at 230 volts.
WARNING:
Grounding information: this machine must be
grounded when used for protecting the user
against possible electric discharge.
WARNING:
Consult a skilled electrician or after-sales
service personnel if you have any doubts about
how to ground the machine. Do not change the
plug supplied with the suction fan. If the power
point does not adapt to it, an authorized
electrician must install a suitable one.
2.5

ON/OFF SWITCH

The on/off switch is located on the side of the motor. This
suction fan is equipped with a power failure switch. In order
to start it, press the ON button. To stop it, press OFF.
12
ground
neutral
Phase
3 USE
3.1

INTENDED CONDITIONS OF USE

This suction fan was designed for being connected to a
flexible tube for sucking up wood shavings or sawdust.
If the machine's suction outlet size is different, it is
advisable to use appropriate adapters to connect the
machine to the suction fan.
Always check and make sure that the suction bag is
perfectly secured to the manifold with the closing strap.
When the suction bag is ¾ full, empty it to avoid blocking
the suction system.
Before emptying the bag disconnect the suction fan's
plug from the socket and don a facial mask and work
gloves. Release the strap that closes the lower bag and
empty it in a suitable place.
Refit the bag and close the strap again.
4 MAINTENANCE
4.1 OBSERVATIONS
Before performing any type of maintenance make sure
that the equipment is disconnected from the power supply
to avoid accidents of any kind. Maintenance to the
foregoing article must be performed by an authorized
service centre.
Always unplug the suction fan when it is stored. Wind the
power cable properly and set it on the suction fan's base
so that it will not be damaged in any way.
4.2

MOTOR MAINTENANCE

Remove dust and dirt. Blow low-pressure compressed air
onto the motor to remove dirt and dust. The person who
cleans the motor must always wear safety goggles. Dust
build-up might cause the motor to overheat.
4.3 DISPOSAL OF THE MACHINE, PACKING
At the end of the machine life, if the
machine must be scraped, contact
an authorised waste disposal centre
in order to comply with the Standards
for hygiene and environment
safeguard.
The packing must be disposed of
according to the ruling standards by
delivering it to authorised people for
the collection, disposal or reclaim.
2002/96/EC