Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
M3.5 x 15 mm Washer Head
(16 used in this step)
N
24. Now, go back and securely tighten all the Cam Locks and the Screws. Make sure that all the parts are
tight and there are no gaps between the parts. This will help keep the unit square.
25. Flip the assembly around at its front edges.
26. Pick up the Back Panel (N) and align the pre-drilled holes against the upper long edge with the pilot
holes on the back stretcher of the Top Panel (A). Attach the Back Panel (N) in place using the provided
Washer Head Screws (8).
Assembly Instructions
Screw
⑧
22
8
Publicidad
Tabla de contenido
