Roscoe Medical nebGO Manual Del Usuario página 9

7. To insert the medication cup into the device, align the three prongs on the back of the medi-
cation cup with the three trenches of the main device and press down. There will be
an audible click.
8. Flip open the medication cup cap.
Fill nebulizer cup using eyedropper or syringe with prescribed medication. DO NOT fill more
9.
than 6 ml per treatment.
10. Close the nebulizer cap, ensuring a tight seal.
11. Press the mouthpiece or mask directly onto the medication cup opening.
12. If using the mouthpiece, place it between your teeth, with lips firmly sealed around the
mouthpiece. If using the mask, place it over the mouth, firmly sealed over the area around
the mouth.
13. Press the ON/OFF button on the top of the device to power the unit on. The light indicator
will be green.
14. Breathe in and out slowly and deeply through the mouth until aerosol treatment is complete.
NOTE: Tilt the device slightly to ensure all residual medication contacts the mesh and is
completely aerosolized.
15. Press ON/OFF button to power the device off. The light indicator will be unlit.
16. Unplug the power adapter from the electrical outlet (if using).
17. Detach the mouthpiece or mask from the device.
18. Remove the medication cup from the device by pressing the button under the cup and
carefully lifting the cup up simultaneously.
19. Clean and disinfect ALL nebulizer components before the next treatment. See pages 10-11.
• The device has a thermal protector, which will shut off the unit before it becomes over-
heated. When the thermal protector shuts the unit off, please:
a. Press the power button OFF.
b. Unplug the unit from the electrical outlet if using power adapter.
c. Wait 20 minutes for the motor to cool down before starting another treatment.
d. Make sure the air openings are not obstructed and air filter is clean.
• NEVER operate if this unit has a damaged cord or plug, has been dropped in any way,
immersed into water or if it does not work properly. Return it to a service center for
repair.
• If any abnormality occurs, discontinue use immediately until the unit has been
examined and repaired.
• ALWAYS unplug the product immediately after use.
WARNING
9