Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

PACKAGE CONTENTS
A – Speaker Body x1 B – Ground Stake (6.693 in.) x1
Assembly and Installation
1
Attaching and installing the speaker
NOTE: Be sure to read the entire guide before installing the
speaker.
WARNING: Never use a hammer to insert the ground stake (B) into
the ground.
Screw the post (D) onto the speaker body (A).
Insert the wire on the wire connector (C) into the groove located on the
top of the ground stake (B).
Screw the ground stake (B) onto the post (D). Ensure the wire on the
wire connector (C) stays in the center of the groove of the ground stake
(B) to avoid damage to the wire.
Prepare a hole in the installation location. Use a tool such as a
screwdriver (not included) to prepare the installation hole to ensure
that the hole is not larger than the ground stake (B).
Install the speaker in the ground by pushing on the foot step (1) on the
ground stake (B). Do not push on the speaker body (A).
C – Wire Connector (with 36 in. wire
attached to speaker body) x1
2
Connecting the wires
CAUTION: The speaker is designed to connect to a low voltage cable and
a transformer, and NOT directly to AC line voltage.
WARNING: The wire connector (C) contacts have sharp edges for piercing
the main low voltage cable. To avoid injury, do not touch the metal contacts.
CAUTION: The wire from the low voltage power unit should be 12-16 AWG
type underground Low Energy Circuit Cable.
IMPORTANT:
Place the wire connector (C) on opposite sides of the low voltage cable
(not included) from the transformer (not included) where the speaker will
be located.
Align and fit the main low voltage cable vertically to the slot of the wire
connector (C).
Press the wire connector (C) together until it is locked around the main low
voltage cable. The pre-set prongs will pierce the cable insulation and
establish contact with the electrical wire inside.
Once the wire connector (C) is in place, it is recommended to wrap it with
electrical tape (not included).
Low voltage lights can also be connected on the same main low voltage
cable from the transformer.
After the speaker (and any low voltage lights) are installed, turn on the
transformer.
1
Use and Care Guide
LOW VOLTAGE OUTDOOR SPEAKER
D- Post x1
E – M sticker x1
Protect the wiring by routing it in close proximity to the speaker fitting,
or next to a building structure such as a house or a deck.
The landscape wire and connector can also be hidden under stone or
buried under grass at a maximum depth of 6 in. (15.24 cm).
Do not install the speaker within 10 ft. of a pool, spa, or fountain,
or any location that may collect water.
Do not submerge the speaker in water.
Item #1003 317 016
Model #B0029RA-2
F – S sticker x1

Publicidad

Tabla de contenido
loading

Resumen de contenidos para HAMPTON BAY B0029RA-2

  • Página 1 Item #1003 317 016 Model #B0029RA-2 Use and Care Guide PACKAGE CONTENTS LOW VOLTAGE OUTDOOR SPEAKER A – Speaker Body x1 B – Ground Stake (6.693 in.) x1 C – Wire Connector (with 36 in. wire D- Post x1 E – M sticker x1 F –...
  • Página 2: Technical Specifications

    Technical Specifications Normal volume playing time: up to 6 hours on rechargeable battery; continuously if receiving LV current from the transformer. □ Bluetooth version: Bluetooth 4.1 □ Omni-directional sound □ Power supply: AC 12V □ Speaker size: 2.5 inch □ Speaker power: 8W □...
  • Página 3 Setting Up and Operating Multiple Speakers What to know before set up: Determine which speaker will be the Main Speaker and which speaker will be the Satellite Speaker. □ Make sure all speakers are turned OFF. □ For the Main Speaker, toggle the S-M switch to “M”. For the Satellite Speaker, toggle □...
  • Página 4: Care And Cleaning

    Care and Cleaning □ □ Clean the speaker with a soft dry cloth. Do not use any cleaners with chemicals, solvents or harsh abrasives. NOTE: In order to preserve battery life, we recommend bringing the speaker inside your home during the winter if you live in a climate where you will not be using the speaker during the winter.
  • Página 5 If the speaker does not turn on after pressing the ON/OFF button for 2 seconds (as outlined in the Use and Care Guide), then please refer to the below steps to reboot the speaker NOTE Press the ON/OFF button and the PAIR button at the same time for 3 Press the ON/OFF button for 2 seconds to turn on the speaker.
  • Página 6: Montaje E Instalación

    Artículo #1003 317 016 Modelo #B0029RA-2 GUÍA DE USO Y MANTENIMIENTO CONTENIDO DEL PAQUETE ALTAVOZ AL AIRE LIBRE DE BAJO VOLTAJE A – Caja Eléctrica B – Estaca de Tierra C – Conector de Cables (con cable de 36 D - Poste x1 E –Etiqueta...
  • Página 7: Especificaciones Técnicas

    Especificaciones Técnicas Tiempo normal de reproducción de volumen: 6 horas con batería recargable;de forma continuada si recibe corriente de BT desde el transformador. □ Versión de Bluetooth: Bluetooth 4.1 □ Sonido omnidireccional □ Fuente de alimentación: AC 12V □ Tamaño del altavoz: 2.5 pulgadas □...
  • Página 8 Configuración y Funcionamiento de Varios Altavoces Aspectos a tener en cuenta antes de la configuración: Determine qué altavoz será el Altavoz Principal y qué altavoz será el Altavoz Secundario. □ Asegúrese de que todos los altavoces estén apagados OFF. □ Para el Altavoz Principal, cambie el interruptor S-M a "M".
  • Página 9: Mantenimiento Y Limpieza

    Mantenimiento y Limpieza □ Limpie el altavoz con un paño suave y seco. □ No uses limpiadores con químicos, solvents, o productos abrasivos. Para preservar la duración de la batería, recomendamos colocar el altavoz dentro de su casa durante el invierno si vive en un clima donde no va NOTA: a utilizar el altavoz durante el invierno.
  • Página 10 Si la caja eléctrica para suelo no se enciende después de pulsar el botón de encendido/apagado (ON/OFF) durante 2 segundos (tal y como se indica en la Guía de Uso y Cuidado), NOTA consulte los siguientes pasos para restaurarla. Pulse el botón de encendido/apagado (ON/OFF) y el botón PAIR a la vez durante 3 Pulse el botón encendido/apagado (ON/OFF) durante 2 segundos para segundos hasta que se ilumine la luz verde del botón PAIR.
  • Página 11: Fcc Warning

    FCC Warning Caution:The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Tabla de contenido