After Using The Machine; Maintenance Schedule; Important; Vacuum Shoe Maintenance - Euroclean Xtrac Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

A-10 / ENGLISH

AFTER USING THE MACHINE

1
Turn the Power Switch OFF (O). Unplug the Power Cord (G). Coil the cord and hang it from the cord hook.
2
To empty the solution tank, pull the Solution Drain Hose (A) off the upper hose barb. Direct the hose to a designated waste water "DISPOSAL
SITE". Rinse the tank with clean water. Inspect the solution hoses; replace if kinked or damaged.
3
To empty the recovery tank, swing open the recovery tank lid and lift the Recovery Tank (5) off the machine. Empty the tank at a designated waste
water "DISPOSAL SITE". Rinse the tank with clean water. Inspect the recovery hose; replace if kinked or damaged.
4
Remove the brush, rinse with warm water and remove any built-up string, hair or carpet fi bers.
5
Disconnect the Recovery Hose (2) from the Recovery Tank Dome Lid (3) and fl ush with warm water to wash any debris out of the Recovery Hose
and Vacuum Shoe.
6
Wipe the machine with a damp cloth. Do not use abrasive chemicals or solvents.
7
Perform any required maintenance before storage.

MAINTENANCE SCHEDULE

Check / Clean Power Brush
Check / Clean Tanks & Hoses
Inspect & Clean Solution Screen
*Check Carbon Brushes
* Have a Euroclean service technician check the vacuum motor carbon brushes once a year or after 300 operating hours. The brush motor carbon
brushes check every 500 hours or once a year.

IMPORTANT!

Motor damage resulting from failure to service the carbon brushes is not covered under warranty. See the Limited Warranty Statement.
8
Store the machine indoors in a clean, dry place with the tank dome lid open. Keep from freezing.
9
Place the machine in the storage position. This will prevent the brush from taking a "set", and will increase the brush life and maintain the
performance of the brush. See Figure 7. Lift up on the base of the machine and rotate the Brush Storage Position Lever (9) backwards to latch
the base in the storage position.
FIGURE 7
For more compact storage loosen the Handle Adjustment Knobs (C) and push the handle down onto
the recovery tank.

VACUUM SHOE MAINTENANCE

Check the vacuum shoe daily. Remove any built-up string, hair or carpet fi bers.
A-10 - FORM NO. 56041626 - Xtrac
MAINTENANCE ITEM
Clean Vacuum Shoe
Clean Spray Nozzle
Daily
Weekly
Monthly
Yearly
9

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido