Charge The Jabra A210; Pair (Connect) With Your Bluetooth® Headset; Adjust The Settings To Suit Your Phone; Turning The Jabra A210 On And Off - GN Netcom Jabra A 210 Manual Del Usuario

1
Charge Jabra A210
The Jabra A210 uses a rechargeable battery that must be charged fully before you use
the adapter for the first time.
1. Use the AC adapter to charge the Jabra A210
from a power socket. (See Fig.2). Only use a
Jabra adapter to charge the Jabra A210.
2. The red light (LED) will turn on when
charging begins. After approximately 2 hours
the red LED will turn off, indicating that charging
is complete.
NOTE: The red LED will flash when the battery is
low. You can continue to use your Jabra A210
Bluetooth adapter while charging.
You are now ready to "pair" the Jabra A210 with
your Jabra Bluetooth headset or speakerphone.
(See Section 2)
2
"Pair"with your Bluetooth headset
Before you can get started, you will need to pair your Jabra A210 Bluetooth adapter
with your headset or speakerphone.
1. Turn your Jabra A210 on with a press of the on/off button. The blue light (LED)
shows a burst of flashes and thereafter continues to flash every 3 seconds.
2. Put your Jabra Bluetooth headset or speakerphone into pairing mode by following
the instructions in its user guide.
3. Put your Jabra A210 into pairing mode by pressing the pairing stylus switch marked
( ) with the stylus. When the blue LED turns solid blue the adapter is in pairing
mode.
4. The pairing is complete when the blue LED flashes every 3 seconds.
4
3
Adjust the setting to suit your phone
To optimize the operation of the Jabra A210 with your mobile phone,
adjust the "3-position setting switch" (See Fig. 3).
•
Set the switch to position 1 if you are using a Motorola
phone
•
Set the switch to position 3 for all other phone makes
•
If you experience echo when using your phone, move the
switch to position 2
•
If you continue to hear echo turn down the volume on the headset
The headset does not have to be on to adjust the 3-position setting switch.
USING YOUR Jabra A210
BLUETOOTH ADAPTER
Fig. 2
To use your Jabra A210 Bluetooth adapter, ensure it is switched on and plugged into
the headset jack in your mobile phone.
NOTE: For complete instructions on operating your Jabra headset, please refer to
the headset's user manual.
4

Turning the Jabra A210 On and Off

To turn the adapter on, press the on/off button. The blue light (LED) shows a burst of
flashes and thereafter continues to flash every 3 seconds.
To turn the adapter off, press and hold the on/off button for 5 seconds.
NOTE: The blue LED will turn off after 5 minutes. To check if your Bluetooth adapter
is on, just tap on the on/off button, and the blue LED will resume flashing. If the
blue LED is not responding, the adapter is turned off.
To save power, your Jabra A210 Bluetooth adapter goes automatically into
standby mode one minute after usage.
Do not use keypad tones with your Jabra A210 as this will affect the
battery performance.
Fig. 3
5