Akasa FREEDOM FORCE Instrucciones De Instalación página 4

3. Note: The cooler's mounting is pre-set to Type B (see Product Compatibility).
If your VGA card has Type A or C mounting follow the next step otherwise
proceed to step 4.
To adjust the mounting dimensions unscrew the metal clips from the base (a),
pull the four standoffs (Part D) out or the rubber seals (Part F) and place them
in the required holes (b). Secure the standoffs with rubber rings and reattach
the metal plates.
4. Position the cooler over the VGA card, aligning the standoffs with the four
mounting holes available around the GPU and put the cooler through until
there is contact.
Note: If the cooler cannot be fitted properly because of fouling
components, cease installation.
5
5. While supporting the cooler with your hand gently turn the VGA over.
Locate the four standoffs from the akasa cooler and place the plastic
insulation washers (part B) over each of the four screws.
6. Secure the cooler with the collar nuts (part E), one for each screw, tighten
the nuts gradually in a crosswise manner.
Note: Do not over tighten the screws as it can damage the VGA card.
Some VGA cards have memory chips on both sides of the board. To cool
the chips on the back side of the card or voltage regulators use akasa
AK-VMC-01BK memory heatsinks.
1
4
3
2
6