Preliminary Warnings - Ferplast BLUCLIMA 50 Manual De Uso

GB
BLUCLIMA
Attention: disconnect all the appliances in
IT
the aquarium or bowl before carrying out any
installation or maintenance work.
FR
INSTALLING BLUCLIMA

Preliminary warnings:

• Ensure that the voltage shown on the heat-
D
er label corresponds to that of your home
electrical power supply.
NL
• The heater is intended for indoor use.
• Ensure that your home is protected by an
automatic breaker switch with an operating
ES
current of no more than 30 mA.
• Do not connect the heater to the power
supply when it is not submerged in water.
PT
• After immersing it in the water, wait a few
minutes before switching it on, so that the
RU
thermostat can adjust to the temperature
of the water.
• Always ensure the water level stays above
SK
the 'minimum water level' mark shown on
the heater.
CS
• To avoid possible breakages due to thermal
shock, the heater should be disconnected
from the power supply at least 5 minutes
HU
before taking it out of the water or before
adding or changing the water.
• The power supply cable cannot be repaired
SV
or replaced: if damaged, the whole heater
must be replaced.
DA
• The heater can be immersed in water to a
maximum depth of 1 m.
• When connecting the heater to the power
PL
supply, ensure that the lowest point of the
6
cable is lower than the electrical socket so
that drops of water do not accidentally run
down the cable and into the power supply
(Fig. 1).
• This appliance can be used by children aged
from 8 years and above and persons with
reduced physical, sensory or mental capa-
bilities or lack of experience and knowledge
if they have been given supervision or in-
struction concerning use of the appliance
in a safe way and understand the hazards
involved.
• Children shall not play with the appliance.
Cleaning and user maintenance shall not be
made by children without supervision.
• Keep the appliance and its cord out of reach
of children less than 8 years.
THE IDEAL POSITION AND RIGHT POWER
• Position the heater at a point in the aquarium where there
is good water circulation; otherwise the thermostat will not
work at its maximum efficiency and the set temperature may
not be reached.
• Choose a heater of the right power (Watt) according to
aquarium capacity, room temperature and required temper-
ature increase (Fig. 2).
INSTALLATION AND OPERATION
• The suckers to the heater, making sure they are positioned
as in the illustration; the suckers must only be attached to
the upper part of the heater and away from the heating
element (Fig. 3).
• Install BLUCLIMA vertically in the aquarium in an area with
good water circulation; this will ensure the best heat distri-
bution and thermostat operation. Attach the suckers to the
previously cleaned glass and push firmly.
• For proper operation, the water level should not go below the
'minimum water level' mark
• The heater does not require any maintenance, apart from
regular cleaning of the glass tube to remove any build-up of