Key Sound (C3); Contrast (C4); Baud Rate (C5); Calibration (C6) - Vetus ECGPS Manual De Manejo Y Instrucciones De Instalación

4.1.3 Key sound (C3)

The key sound can be switched on or off.
• Press in the default mode to enter
the menu.
• Use the /
the Key Sound menu (C3).
• Press to enter the Key Sound
menu.
• Use the /
ON or OFF.
• Press
menu or
• Keep pressed for two seconds
to exit to the default mode.

4.1.4 Contrast (C4)

The display of the compass/GPS can be
adjusted for different viewing angles.
Contrast level can be set from 0 up to 9.
• Press in the default mode to enter
the menu.
• Use the /
the Contrast menu (C4).
• Press to enter the Contrast
menu.
• Use the /
the contrast level.
• Press
menu or
• Keep pressed for two seconds
to exit to the default mode.

4.1.5 Baud rate (C5)

The compass/GPS has auto baud rate
detect. This menu can be used to send
a preferred baud rate to the connected
compass sensor.
• Press in the default mode to enter
the menu.
• Use the /
18
100506.01
buttons to select
buttons to select
to return to the main
buttons to select
buttons to select
to return to the main
buttons to select
the Baud rate menu (C5).
• Press to enter the Baud rate
menu (C5).
• Use the /
the baud rate.
• Press
menu or
• Keep pressed for two seconds
to exit to the default mode..

4.1.6 Calibration (C6)

Magnetic deviation, caused by the vessel
itself, results in incorrect compass read-
ings.
This magnetic deviation can be corrected
by means of the calibration procedure.
• Press in the default mode to enter
the menu.
• Use the /
the Calibration menu (C6).
• Press to enter the Calibration
menu.
• Use the /
Auto or Manual.

4.1.6.1 Automatic calibration

The electronic compass has an automatic
calibration procedure. Default 'Auto Cali-
bration' is 'ON'.
The compass sensor will calibrate itself
every time two full circles at a constant
speed have been made within 1 to maxi-
mum 4 minutes per circle.
You can switch this function OFF and use
the manual calibration command.

4.1.6.2 Manual calibration

To calibrate the compass sensor you need
a calm day and a clear area. Start turning
your boat in a large circle at a constant
speed. Then select calibrate in the menu
and press and
Electronic Compass / GPS ECGPS
buttons to select
to return to the main
buttons to select
buttons to select
buttons togeth-