BS POOL PRO Serie Manual Mantenimiento página 24

Installation of the cleaning system using the following photo/diagram:
Once installed, stop filtration and close the inlet and outlet valves of the cell
Place the floats in the cleaning chamber of the cell
Open the ¾" valves and turn on the cleaning pump, following the instructions on the
electrical panel.
Wait for the cleaning to take place or until the fluid has neutralised itself.
Check that the cell is clean.
If incrustations persist, start the cleaning cycle again.
Close the ¾" valves
Open the input and output valves.
Turn the filtration on
Check that the screen is showing the correct values
24