Dust Collection - American Sanders OBS-18 Manual Del Operador

Section - A
This sanding machine is designed to be operated with a remote vacuum. dust collection system or with the included dust bag
Preparing Remote Vacuum Dust Collection Systems
To prepare the machine for remote vacuum dust collection
systems that have a 2" hose end, follow this procedure:
1. Install 2" hose end (Figure 4 - A) directly into the
exhaust tube (Figure 4 - B).
2. The exhaust tube can be rotated for optimum
convenience.
To prepare the machine for remote vacuum dust collection
systems that have a 1-1/2" hose end, follow this procedure:
1. Install 2" hose end (Figure 4 - A) directly into the
exhaust tube (Figure 4 - B).
2. The exhaust tube can be rotated for optimum
convenience.
NOTE: Start the remote vacuum collections system before
operation.
2" Hose from Vac-
A
uum System
(Not included)
Figure 4
B
Exhaust
Tube

Dust Collection

1-1/2" Hose from
D
Vacuum System
(Not included)
(30563A)
2" Tube X 1-1/2"
C
Hose Adapter
Preparing Using the Dust Bag
To prepare the machine for use with the included dust bag
(Part No.53741A), follow this procedure:
1. Install the dust bag by pressing the end onto the
exhaust tube until the ring locks into the groove (Figure
5). This is best done by pressing on the back of the bag
opening with the palm of your hand.
2. The exhaust tube can be rotated for optimum
convenience.
3. To remove the dust bag from the exhaust tube, pry
up the end of the bag opening to partially release the
internal rib from the groove, then pull.
4. To empty the dust bag, unzip the disposal flap and force
contents out by inverting the bag.
NOTE: For best results, empty frequently. Follow all
warnings posted in this manual and on the dust bag.
Install the dust bag by pressing the
end onto the exhaust tube until the
ring locks into the groove
8
English - EN
.
Figure 5