Halley ICV 22 Manual Del Usuario página 19

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

EXERCISE COMPUTER INSTRUCTION MANUAL
The unit is an electronic that display all workout parameters on LCD display. The workout parameters
include: Odometer (if have), Time, Speed, Distance, Calories and Pulse (if have). All workout parameters
may be selected by the select key.
MODE OR FUNCTION
Power on:
If push the button, the unit will be on and display the parameters of the last exercise..
Sélection:
If push the button, the unit will be on and display the parameters of the last exercise. Push the
fonction Scan:
button, the unit will display 5 parameters one by one. Push the mode key until the "SCAN" signal
shows on right down side. The unit will scan by through Time, Speed, Distance, Calories each
for 4 seconds.
Odomètre :
Push the mode key again, the scan will stop and the "SCAN" signal will disappear. Push the
(si disponible)
button until the "ODO" points to "ODO", to display shows the odometer on the meter. The reading
of the odometer will be reset to zero after replacing the batteries. Unit: km (or ml)
Time:
Push the mode key until the "TMR" points to "Time" To display the exercises time. If bike stop
moving, the unit will stop count time also.
Speed:
The speed value is display from beginning to end. Unit: km/h (or ml/h)
Distance:
When the "DIST" point to "Dist" to display the distance value. Unit: km (or ml).
Calories:
When the "CAL" points to "CAL" to display the calories value. Unit: kcal.
Pulse (If have):
When the "PULSE" points to "pulse" to display the heart rate of biker in per minute. If the sensor
is contact with ear, clip the sensor to earlobe before measuring your rate. If the pulse sensor is
contact with hand place the palms of your hands on the both of the contact pads before measu-
ring your pulse rate. If the pulse signal is not in put over 30 second, the unit will return the
"Time" function.
Reset:
Push the mode key over 3 seconds the showing will become to zero
Auto off :
The unit will be off if the speed signal stops over 4 minutes
FUNCTION
CONTROLLER
BATTERY TYPE
OPERATING TEMPERATURE
STORAGE TEMPERATURE
SPECIFICATIONS
Auto Scan
Elapsed Time
Speed
Distance
(have pulse/no pulse)
Calorie
Odometer
(have pulse/no pulse)
Pulse
8 (or 4) bit single chip microprocessor
AA ou UM-3
0° ~+40ºC
-10° ~+60ºC
ICV 22
Every 4 seconds
00:00~99:59
0.0~99.9
0.00~99.99/0.000~9999
0.0~999.9
0.00~9999/0.000~9999
40~180/min
19

Publicidad

Tabla de contenido
loading

Tabla de contenido