Response-Link MCT-212 RL Manual De Instrucciones

MCT- - - - 212 RL MCT 212 RL
MCT MCT 212 RL 212 RL
Showerproof
English
PowerCode Wrist
Transmitter –
User Guide
Transmisor
Español
Impermeable de
Pulsera
PowerCode -
Guía de Usuario
ENGLISH (GB/US) ENGLISH (GB/US)
ENGLISH ENGLISH (GB/US) (GB/US)
1. INTRODUCTION
The MCT-212 RL is a miniature showerproof transmitter, designed
for home health care signaling. In the event of an emergency, help
can be summoned at the press of the transmitter button.
All MCT-212 RL units are supplied with a wrist band and neck
strap. They can be worn on the wrist or around the neck.
The LED lights during a transmission to indicate a good battery. If the
LED flashes during a transmission, this means that the battery is low
and must be replaced immediately. Anytime the MCT-212 RL is
pressed when the battery is low, a trouble signal will automatically be
sent to the Base Unit.
To alert you of the trouble, a red LED will flash and a trouble
message will appear on the display of the Base Unit. All troubles
are reported to the Monitoring Center.
The transmitter case is hermetically sealed (no screws) to ensure
complete showerproofing of
replacement must be performed by the factory only.
2. TEST, MAINTENANCE &
ENROLLMENT
2.1 Enrolling Transmitters
I
n order for a transmitter to function, its ID must be enrolled into
the Base Unit. The Transmitter ID is a 6 character code (ex:
EB1772) that can be found both on the unit's package and on the
reverse side of the unit. To enroll a transmitter, provide
ResponseLINK (either by telephone or by fax) of the Transmitter
ID.
2.2 Initial Test
Upon pressing the transmit button, the Base Unit will sound
and display simultaneously CALLING FOR HELP. This
indicates that the transmitter is working properly.
Note: If for any reason the MCT-212 RL does not result in the
above response from the Base Unit, please contact the central
station at 1-800-894-1428 and verify the Transmitter ID located
both on the unit's package and on the reverse side of the
transmitter beneath the wrist band.
3. GENERAL COMMENTS
Product Limitations
Our wireless systems are very reliable and are tested to high
standards. However, due to their low transmitting power (required
by FCC, DTI and other regulatory authorities) there are some
limitations to be considered:
A. Receivers may be blocked by radio signals occurring on or
near their operating frequencies, regardless of the code
selected.
B. A receiver can only respond to one transmitted signal at a time.
IF YOU HAVE ANY QUESTIONS PLEASE CALL (800) 894-1428.
D-2457-RLES
GB/US: Transmit
Button
SP: Botón de
GB/US: Loop
transmission
SP: Hebilla
GB/US: LED indicator
SP: Indicador LED
GB/US: Fastener
SP: Seguro
MCT-212 RL with Wrist Band / RL
con Pulsera para Muñeca
the case. Therefore battery
GB/US: Safety release
mechanism
SP: Mecanismo
de liberación
de seguridad
GB/US: Fastener
SP: Seguro
MCT-212 RL with Neck Strap /RL con correa para el cuello
C. Wireless equipment should be tested regularly (at least once a
week) to determine if there are sources of interference and to
protect against faults.
4. SPECIFICATIONS
Frequency (MHz): 315
Transmitter ID: Over 16 million possible code combinations.
Transmit Duration: Up to 5 sec
Power Supply: 3-volt Lithium cell type CR-2032 Sanyo or Hitachi
Maxcell only
Battery Life Expectancy: 3 years (for typical use)
Battery Supervision:
Good battery - LED lights steadily upon activation.
Low battery - LED flashes upon activation.
Note: If transmission is still possible despite the battery condition,
the MCT-212 RL will send a low battery report to the receiver.
Operating Temperature: 0° to 50°C (32° to 122°F).
Dimensions: 39 x 37 x 13 mm (1-9/16 x 1-7/16 x 5/8 in.).
Weight: 25 g (0.9 oz).
Color: Gray
This device complies with Part 15 of the FCC Rules and RSS-210
of Industry and Science Canada. Operation is subject to the
following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference
received, including interference that may cause undesired
operation.
WARNING: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the
user's authority to operate the equipment.
The digital circuit of this device has been tested and found to
comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in residential
installations. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference
to radio and television reception. However, there is no guarantee
that interference will not occur in a particular installation. If this
device does cause such interference, which can be verified by
turning the device off and on, the user is encouraged to eliminate
the interference by one or more of the following measures:
– Re-orient or re-locate the receiving antenna.
– Increase the distance between the device and the receiver.
– Connect the device to an outlet on a circuit different from the
one which supplies power to the receiver.
– Consult the dealer or an experienced radio/TV technician.
W.E.E.E. Product Recycling Declaration
For information regarding the recycling of this product you must contact the
company from which you orignially purchased it. If you are discarding this
product and not returning it for repair then you must ensure that it is returned
as identified by your supplier. This product is not to be thrown away with
everyday waste.
Directive 2002/96/EC Waste Electrical and Electronic Equipment.
GB/US: Neck cord
SP: Colgante para
el cuello
1