CertainTeed NO-COAT PRO Manual De Instrucciones página 10

(entering the data), the asterisk "*" will change to "<" indicating that the line is being
edited. For example, two corners measuring 6 feet, 3 5/8 inches would be entered as:
"6"............... "FT"
"3"..............."IN"
"5"..............."1/8s"
"2"..............."QTY" (NOTE: if quantity step is skipped, the quantity defaults to 1)
2. Check the display on the NO-COAT PRO to be sure that it displays the corner
data correctly. If you make a mistake at any time while entering measurements and
quantities, you can override the data by re-entering it correctly.
3. Press ENTER to store this line in the list and advance to the next corner entry line.
4. Continue entering corners in this manner until you have entered all the corners that
you would like to run in one batch.
Viewing data
1. Press the "^"scroll arrow (up) to scroll upwards in the list.
2. Press the "v" scroll arrow (down) to scroll downward in the list.
Editing data
1. To edit an entry, use the scroll arrows until the asterisk "*" is next to the line you
want to edit.
2. Retype the measurement that you need to change (FT, IN, 1/8s, or QTY).
3. When you are done editing, press ENTER so that the NO-COAT PRO keeps your
changes.
Deleting data
Deleting all data:
1. To delete all of your entered corner data in the current list, press and hold DELETE
for 2 seconds.
2. Press ENTER to confi rm that you want to delete all.
Deleting one line:
1. Scroll through the lines of data until the entry you need to delete is on the third line
of the display.
2. Press DELETE.
Storing/recalling data
The NO-COAT PRO can store lists of corners in MEMORY STORE so that they can easily
be recalled. The NO-COAT PRO can store up to ten lists at a time.
1. Enter your measurements, one after the other, as described above, until your list is
complete.
2. Press MEMORY STORE and a corresponding memory number (i.e. "MEMORY 1").
3. When you are ready to reuse the list, simply press MEMORY RECALL and the
corresponding memory button.
4. If a Memory button is full of data and you wish to override the data with new
information, enter your new measurements and quantities, press MEMORY STORE and
a corresponding memory number. This will override the previous list.
®
18 NO-COAT PRO INSTRUCTION MANUAL