Pedometer Mode; User Profile - SUPERDRY SPORT Digi Manual De Instrucciones

4. Pedometer Mode

NOTE: You must be in pedometer mode to track activity continuously. Steps will not be recorded if you leave this mode.
To remain in Pedometer mode use the lock function by holding the UP button until (
To exit lock function, hold the UP button until (
Displays
In the pedometer mode the watch uses G-Sensor technology to track and record your daily activities. You
must be in this mode to activate the G-Sensor and track activity. Within this mode you will be able to cycle
through 3 different displays using the UP button - Step/Time, Step/Activity Time, Calorie/Mileage. These
displays are shown below:
STEPS
Step / Time

User Profile

To more accurately measure your step count, calorie burn and distance travelled you can set up an
individual user profile. This will tailor the watch to you and your needs.
- In pedometer mode, hold MODE button until KG/LB indicator starts to flash.
- Press UP or DOWN button to adjust the flashing value.
- Press MODE button to cycle through settings, as below diagram.
Metric / Imperial
Cycle between
with UP or
DOWN
Metric / Imperial
Metric/Imperial - Default is metric. Press UP or DOWN to switch between metric & imperial.
Weight - Default weight is 60kg (132lb). Adjustable range is 20-200kg / 66-440lb.
Stride Length - Default stride length is 70cm (28in). Adjustable range is 30-150cm / 12-59in.
Sensitivity of G-Sensor
) disappears.
Press UP
Step / Activity Time
NOTE: The flashing unit is the one which will change - shown below in
Weight (Kg)
To change each setting press UP or DOWN buttons accordingly.
Weight (lb)
- Default MIDDLE. Recommendation: LOW - Jogging / HI - Fast running.
)
appears. Battery life can be reduced with regular use.
STEPS
Press UP
GREEN.
Stride Length (cm)
Stride Length (in)
6
KCAL
KM
Calorie / Mileage
Sensitivity Low
Cycle between
with UP or
DOWN
Sensitivity High