Asme Compliant Suction Fitting Info - Polygroup SUMMER WAVES CP2000-C Manual Del Usuario

Ocultar thumbs Ver también para SUMMER WAVES CP2000-C:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ASME COMPLIANT SUCTION FITTING INFO

PSF-100A and PSF-100B Suction Outlet Fitting (For Aboveground Pool)
1. PSF-100A and PSF-100B Suction Outlet Fitting are certified by IAPMO in accordance with the ASME/ANSI/APSP/ICC-16 2011 Suction Fittings for Use in
Swimming Pools, Wading Pools, Spas, and Hot Tubs.
2. This is a submerged suction outlet fitting for use with aboveground swimming pool.
3. For single drain only. Use only ONE outlet fitting for each pump.
4. Do not locate this suction outlet fitting on sitting areas or on the backrest for such seating area.
5. Install this outlet fitting at location recommended by the pool manufacturer. Maximum height 1.8 m from the ground.
6. The maximum allowable flow rate of this suction outlet fitting is 24 gallons per minute (1,440 gallons per hour).
7. Connection hose:
a. Model PSF-100A is to be connected with 1 ¼" (31.8mm) diameter hose.
b. Model PSF-100B is to be connected with 1 ½" (38.1mm) diameter hose.
8. The suction outlet fitting is to be mounted at the suction outlet fitting opening as specified by the manufacturer of the aboveground pool. The diameter of this
opening should be within the range of 1.77" to 1.85" (45mm to 47mm). Refer to the following diagram for detailed assembly instructions:
9. PSF-100A or PSF-100B Suction Outlet Fitting is to be replaced every 5 years.
10. No tool is required for installation.
11. Service & winterizing instructions:
a. CAUTION! DO NOT EXCEED THE MAXIMUM ALLOWABLE FLOW RATE: 24 gallons per minute (1,440 gallons per hour)
b. Carefully observe and inspect the suction outlet fitting for damage and tampering. Missing, broken or cracked suction outlet fitting must be replaced before
each use of your pool.
c. Loose suction outlet fitting should be reattached or replaced before each use of your pool.
d. Remove and store the suction outlet fitting assembly if temperatures are expected to fall below 32°F (0°C).
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8AM to 5PM MST, Monday-Friday.
Extended operating days and hours during peak season requirements.
OWNER'S MANUAL
Swimming Pool
Rubber Gasket
Suction Fitting, PSF-100A
or PSF-100B
Water Cap, to be installed only
during pump maintenance
or filter cartridge replacement
Flat Washer
Lock Nut, to be tightened by hand
Hose Clamp
Hose
15

Publicidad

Tabla de contenido
loading

Tabla de contenido