Installing On Carpeting - LG STYLER Manual Del Propietário

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLING ON CARPETING

If installing the Styler on carpeting, follow these
instructions.
WARNING
y The Styler is heavy. Use two or more
people to install the rear leveling feet and
carpet spikes. Failure to do so can result in
back injury or other injury.
y Keep the Styler upright when moving
and installing it. If you lay the Styler on
its side, refrigerant may leak and cause the
appliance to malfunction.
1 Move the unit into its final location using
the back rollers.
2 Install the two rear leveling feet.
Tip the unit, do not lay it down, to install the
leveling feet.
3 Level the unit following the instructions in
Leveling the Styler.
4 Install the four carpet spikes
on the ends of the leveling
feet, with the shorter,
octagonal faces toward the
front.
MFL66101258_EN.indd 17
5 After the spikes have been installed, the
Styler may need to be leveled again.
If the carpet has very deep pile or padding,
the front feet may need to be extended
slightly to install the drip tray.
WARNING
y Take care when handling the carpet spikes.
They are designed to pierce through the
carpet backing and pad and are very sharp.
y Keep fingers and hands out from under
the spikes when setting the unit in place to
avoid personal injury or product damage.
• Be sure to check and empty the drip tray often.
• Do not open the unit during operation to avoid
condensation forming on carpet surface,
which may result in surface mold or mildew.
• Keep the bottom of the cabinet dry when
filling or emptying water tanks. Keep the
outside of the water tanks clean and dry to
discourage growth of mold or mildew.
front
USING NON-SKID PADS
(OPTIONAL)
Non-skid pads prevent the product from shaking
or shifting when opening or closing the door.
1 Clean the floor to attach the non-skid
pads. Use a dry rag to remove and clean
foreign objects or moisture. If moisture
remains, the non-skid pads may slip.
2 Adjust the level after placing the Styler in
the installation area.
INSTALLATION
17
2019. 2. 11. 오전 10:55

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido