LIST OF COMPONENTS
A Arms
B Clamps
C Support Arms
D Front Safety Strap
E
Waist Belt
F
Central Buckle
G Crotch Strap
H Lining
I
Locking Pins
J
Chair Support Pipe
K Lower Support Arms Cover
L
Rigid seat Support
not been damaged during transport or handling. If any damage exists, no matter
how slight, DO NOT USE THE CHAIR.
Contact Inglesina for any necessary replacement parts.
ASSEMBLY OF THE SUPPORT ARMS
The Support Arms (C) are delivered disassembled.
Place the plastic rings of the front safety strap (D) over the support arms (C). Slide
the support arms (C) into the frame of the Fast Seat.
The spring loaded locking pins (I
in order to lock the support arms (C) in place. DO NOT zip the lower support arms cover
over the support arms (C).
POSITIONING CHAIR
Place the hook-on chair close to the table and slide the arms (A) along the top of
the table. Push the hook-on chair all the way forward to the edge of the table. The entire
bottom surface of the arms (A
the support arms (C) are properly in place under the table.
Screw the clamps (B) by rotating them counterclockwise until reaching the bottom
of the table. Tighten the clamps (B) at least three (3) full turns after the clamp (B
contacts the bottom of the table.
Zip the lower support arms cover (K) over the support arms (C), covering the
support arms (C) and clamps (B).
table by trying to pull it away from the table and downwards. Do not place a
child in the hook-on chair if chair moves at all during this test. Failure to securely
anchor the hook-on chair can result in an accident, personal injury or death.
if the clamps (B) fully contact the underside of the table. There is a risk the hook-
on chair will detach from the table, resulting in an accident, personal injury or
death.
not ensure full contact between the entire bottom surface of the arms (A) and the
top of the table, and the clamps (B) with the bottom of the table. There is a risk
the hook-on chair will detach from the table, resulting in an accident, personal
injury or death.
INSTRUCTIONS
13