Alarm.Com ADC-VS121 Guia De Instalacion

Required Items for Installation:

Video Server and power adapter (included)

Broadband (Cable, DSL, or Fiber Optic) Internet
connection with router

Personal computer or web-enabled tablet

Login/Password for the customer's Alarm.com account

Analog CCTV camera with power supply (not included)

RG-59 or RG-6 coaxial cable with BNC connectors

Ethernet cable
Install the Video Server(s):
1. Use the coaxial cable to connect the analog camera to the BNC
connector on the Video Server.
2. Use a standard Ethernet cable to connect the Video Server to
the network router.
3. Connect the Video Server's AC adapter and plug it into a
non-switched outlet.
4. From a computer on the same network as the Video Server,
log into the customer's account at www.alarm.com/login.
5. Type www.alarm.com/addcamera into the web browser's address
bar and follow the on-screen instructions to add the camera to
the Alarm.com account.
Contact Alarm.com Dealer Support at support@alarm.com or find your local number
Questions?
at the following website http://alarmadmin.alarm.com/Support/Phone.aspx
US and Canada: 1.866.834.0470 | MX: 001.855.300.9897
Alarm.com, Inc. ©2000-2013 All rights reserved. www.alarm.com.
INSTALLATION GUIDE
Video Server
(ADC-VS121)
Alarm.com Video Server
Coaxial Cable
Ethernet Cable
AC Adaptor
(required only
during setup)
*If you experience difficulties with the camera set up
process, hold down the reset button with a paper clip for 10
seconds to reset the server.
EZ.INSTALL
Network Router
Modem
PC
Internet
TM