Measurement Procedure; How To Use The Memory; Clearing Values From Memory; How To Adjust The Time - Alvita MA801f Manual De Instrucciones

Measurement Procedures
1. Press the ON/OFF/START button. All displays will appear for approximately
one second before returning to "0".
2. The unit will automatically inflate to the appropriate inflation level based on your
pulse oscillations. Measurement will then begin. It is important to remain still and
quiet during measurement. Any significant movement may affect measurement
results.
3. Press the ON/OFF/START button to turn the monitor off. If no button is pressed,
the unit will shut off automatically in 1 minute.
This monitor will re-inflate automatically to approximately 220 mmHg if the system
detects that your body needs more pressure to measure your blood pressure.
Note:
1. To interrupt the measurement, simply press the Memory or ON/OFF/START
button; the cuff will deflate immediately.
2. During the measurement, do not talk or move your arm or hand muscles.

How to use the memory

Recalling values from memory
1. The monitor has two memory zones (1 and 2). Each zone can store up to 60
measurements.
2. To read memory values from a selected memory zone, use the User-Switching
button to select a memory zone (1 or 2) from which you want to recall values.
Press the Memory button, the first measurement displayed is the average of the
last 3 measurements stored in memory.
3. Continue to press the Memory button to view the last previously stored
measurement. Every measurement comes with an assigned memory
sequence number.
Note: The memory bank can store up to 60 measurements per memory zone.
When the number of measurements exceeds 60, the oldest data will be replaced
with the new record.
10

Clearing Values from Memory

1. Press the User-Switching button to select memory zone 1 or memory zone
2. Press and hold the Memory button for approximately 5 seconds, then the data in
the memory zone can be erased automatically.

How to adjust the time

1. When the batteries are first inserted and after they are replaced the display will
show the date and time only until these values have been set. The day will be
flashing which indicates that it can be changed.
2. To increase the day by one, press the Memory button. When you have reached
the correct day press the ON/OFF/START button to confirm, then month will start
to flash.
3. Change the month, the hour and the minute as described in Step 2 above, using
the Memory button to change and the ON/OFF/START button to confirm the
entries.
4. "0" will reappear as the Blood Pressure Monitor is ready for measurement.

Battery Installation

1. Press down and lift the battery cover in the direction of the arrow to open the
battery compartment.
2. Install or replace 4 "AA" sized batteries in the battery compartment according to
the indications inside the compartment.
3. Replace the battery cover by clicking in the bottom hooks first, then push in the
top end of the battery cover.
4. Replace all the batteries at the same time. Remove batteries when unit is not in
use for extended periods of time.
You need to replace the batteries when
1. The low battery icon appears on display.
2. The ON/OFF/START button is pressed and nothing appears on the display.
Caution:
1. Batteries are hazardous waste. Do not dispose them together with the
household garbage.
2. There are no user serviceable parts inside. Batteries or damage from old
batteries are not covered by warranty.
3. Always use branded batteries. Always replace all of the batteries at the same
time. Use batteries of the same brand and same type.
11