Power; Increase Mist Output; Decrease Mist Output - Duux Beam Manual De Usuario

Power

Press the power button to switch on the device.
The corresponding indicator will light up on the
display and the ambient light will switch on. The
WIFI indicator will blink to look for devices to
pair. The monitoring screen will show the actual
temperature and humidity every 5 seconds. Press
again to switch off the device (the device will
remain in stand-by mode until the plug is removed
from the wall outlet). The default humidity setting is
MEDIUM output.
Note: you can also switch on the device with
the touch button on the device, located behind the
control panel / remote control.
Increase /

decrease mist output

Press the button increase the mist output.
The mist output level bars will change accordingly.
Pressing the button will decrease the mist
output. The are three mist output levels:
LOW , MEDIUM ,
HIGH
Note: The mist output setting will not cycle
when pressing or button multiple times.
10
Auto mode
Press the button to activate the self-regulating
hygrostat. The mist output intensity will now
self-regulate according to the ambient relative
humidity. Press multiple times to change the
desired humidity in the following order: 40% > 45%
> 50% > 55% > 60% > 65% > 70% > 75% > 80% >
85% > 90% > ACTUAL HUMIDITY > 40% > 50% > ...
and so on. Each press will increase with 5%. Once
released, the selected humidity will blink 3 seconds
to confirm your choice.
When the hygrostat is set above the actual
humidity, the device will operate in high speed until
the desired humidity has been reached. When
the hygrostat is set below the actual humidity, the
device will not humidify. After setting the hygrostat,
the display will show the ambient relative humidity.
Timer
Press the key to activate the timer setting. With
every touch the timer will increase with one hour in
the following sequence: 1h > 2h > 4h > 8h > OFF.
Once the timer is activated, the device will
automatically shut down after the set timer has
been completed.
Ambient light
Press the button to active the ambient light.
Press again to deactivate.
WIFI mode
Press and hold the button for 5 seconds to
activate the WIFI mode. The indicator will quickly
disappear and then flash rapidly (searching for
devices to pair)
WIFI and APP operation
Scan below QR code to download the Duux APP
or search DUUX APP in the App Store or Google
Play Store to start the procedure to download the
APP. Once installed, enter your e-mail address and
complete the registration.
APP STORE PLAY STORE
Connect to WIFI
Once registered, click "add duux device" on the
1
main screen or use the "+" button in the top
right corner to add a new device.,
Search for "Beam" and press to continue
2
Connect to your preferred WiFi network and
3
enter the corresponding password
Follow the instructions in the app to complete
4
the pairing process.
11