– ALWAYS install the heater so that it is not directly
exposed to water spray, rain, dripping water, or
wind.
– Use heater in accordance with all local codes.
In the absence of local codes, refer to The
National Fuel Code, ANSI Z223.1.
For use with propane (LP)
WARNING
gas only.
– This heater is shipped from the factory
for use with propane (LP) gas only. Do not
convert to any other gas. Installation must
conform to local codes, or in their absence,
with the standard for the Storage and
Handling of Liquefied Petroleum Gases ANSI/
NFPA 58 and the Natural Gas and Propane
Installation Code CSA B149.1.
– Gas supply connections should be checked
by using a 50/50 soap and water solution.
Never use a flame to check for gas leaks.
WARNING
RISK OF FIRE! ALWAYS LOCATE HEATER ON A STABLE AND LEVEL SURFACE!
Figure 1
1. Remove all packing items applied to heater for
shipment. Keep plastic cover caps attached to
inlet connector and hose / regulator assembly
for storage.
2. Remove all items from carton
© 2015, Pinnacle Products International, Inc.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING,
CONNECTED TO A POWER SOURCE, OR WHILE
CONNECTED TO A FUEL SOURCE
Safety Information
material and contact with hot surfaces both
during use and while in storage.
– Locate LP cylinder at least 6 feet (10 ft. in
– Use only the regulator and hose assembly
Unpacking
3. Check all items for shipping damage. If the
3
The hose assembly shall be
WARNING
pro tected from traffic, building
Canada) from the heater, and do not direct
heater discharge towards the LP cylinder
unless it is at least 20 feet from the heater.
provided with this heater. Inspect the
regulator/hose assembly prior to each use of
the heater. If there is excessive abrasion or
wear, or if the hose is cut, replace it with the
proper assembly shown in the parts list, prior
to using the heater.
Minimum and Maximum Inlet Pressure
80V-LPC-B
Min.
Max.
X
heater is damaged, promptly inform dealer
where you purchased the heater.
The Propane (LP) gas
CAUTION
pressure regulator and hose
assembly supplied with the heater must be
used without alteration.
Convection Heater User's Manual
200V-LPC-B
5 PSI
Bottle Pressure