Operation - Defiant MST18R35LWDF Guía De Uso Y Cuidado

Operation

1
Testing the motion sensor
□
Rotate knob on bottom of the sensor (B)
to "TEST".
□
Turn on the power to fixture. Allow fixture to
warm up approximately 40 seconds before
testing. (Lights may not come on during
warm-up period.)
□
Aim sensor head (B) toward desired detection
area, maintaining a 5°–15° down angle to
allow moisture to drain.
□
Walk across the detection zone at the
farthest distance you wish your detector
to detect motion.
□
Adjust sensor head (B) until you get desired
results. Lights will turn off 4 seconds after
all motion stops.
NOTE: For maximum range performance, allow fixture
to operate in any mode (with power to the unit) for at
least 48 hours.
+
Bottom of sensor
TEST
-
TIME
2
Setting the ON time
□
To set the ON time, rotate knob arrow to point
to the desired time setting within the TIME
range (up to 12 minutes).
Example of knob arrow placement
to set duration of ON time
B
8
TEST
-
+
TIME
B