Listening To Files On A Usb Flash Drive; Changing The Volume - Teac NT-503 Manual De Red

Listening to files on a USB flash drive

Connect a USB flash drive to the front USB port.
When you switch the input source to USBf, folders and audio files on
the USB flash drive will be shown.
Tap a folder to show the subfolders and audio files inside it.
Tap an audio file to start playback.
o Do not disconnect the USB flash drive during playback.
Disconnect the USB flash drive only when the unit is stopped or
the input source is not USBf.

Changing the volume

Move the volume slider () shown at the bottom of the screen to
change the volume.
Move it toward the + to increase the volume, and move it toward
the − to decrease the volume.
When using the line outputs
When the line output level is set to VARIABLE, use the volume ()
slider to adjust the volume.
When the line out level is set to any other setting, the volume can-
not be adjusted. Use the stereo amplifier or other device connected
to the unit to adjust the volume.
When using headphones connected to this unit
Use the volume () slider to adjust the volume.
o If headphones are connected to this unit, audio will not be out-
put from the analog audio outputs on the rear panel.
o Use the slider carefully because accidentally moving it
suddenly toward the + could cause very loud volume
output.
o You can also tap the + and − to adjust the volume.
Each tap changes the volume one step. (Continuously touching
these has no effect.)
If the volume () slider does not appear, tap the volume icon () at
the bottom of the screen.
EN
7