Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation instruction of using pedestal base:
1. Loosen the square nut on top of the bracket.
2. Slide the nut onto the track. Set at desired height. Tighten by turning the knob on the back of the bracket.
3. Adjust vertically by loosening the knob on the side of the bracket. Adjust horizontally by turning the bracket arm.
4. Select suitable position on vehicle and fix the base support. (Figure 1) The base has pre-drilled screw holes if needed.
5. Connect the monitor with the AV and power supply conversion cable. (Figure 2)
Stick the base
support onto the
vehicle
Figure 1
IMAGE FOR REFERENCE ONLY
IMAGE FOR REFERENCE ONLY
Remote Control Operation
Horizontal Mirror/Normal Image
Reversing Benchmark
Screen Mode (16:9/4:3)
!
WARNING!
1. Please align the remote control with the remote signal receiver window to operate.
2. Never disassemble the remote control or allow it to drop or get wet.
Figure 2
Mute
Mute
Horizontal Mirror/
Normal Image
Volume Down
Volume Down
Menu
Menu
Standard, Vivid, Soft,
Mode
Light, and User
Guide Lines
16:9/4:3
22 PIN MALE
9 PIN MALE
Analog Increase
Analog Increase
CH
MENU
CH
MODE
RESET
TIMER
16:9
GRID
SEL
4:3
REMOTE CONTROL
Power on/off
Power On
Vertical Mirror/
Vertical Mirror/Normal Image
Normal Image
Volume Up
Volume Up
Analog Decrease
Analog Decrease
Sleep Timer(0-240 mins)
Timer (0~240 minutes)
AV Switchover
AV Switchover
Reset
Reset
Page 3 of 5
Publicidad
Tabla de contenido
