Descargar Imprimir esta página

ASROCK 880GMH/U3S3 Manual De Instrucciones página 25

Publicidad

2.9 Onboard Headers and Connectors
2.9 Onboard Headers and Connectors
2.9 Onboard Headers and Connectors
2.9 Onboard Headers and Connectors
2.9 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
Primary IDE connector (Blue)
(39-pin IDE1, see p.2 No. 8)
connect the blue end
to the motherboard
Note: Please refer to the instruction of your IDE device vendor for the details.
Serial ATAII Connectors
(SATAII_1 (PORT 0):
see p.2, No. 19)
(SATAII_2 (PORT 1):
see p.2, No. 18)
(SATAII_3 (PORT 2):
see p.2, No. 17)
(SATAII_4 (PORT 3):
see p.2, No. 16)
(SATAII_5 (PORT 4):
see p.2, No. 15)
Serial ATA3 Connectors
(SATA3_1: see p.2, No. 24)
(SATA3_2: see p.2, No. 25)
Serial ATA (SATA)
Data Cable
(Optional)
2 4
2 4
2 4
2 4
2 4
ASRock
80-conductor ATA 66/100/133 cable
These five Serial ATAII (SATAII)
connectors support SATAII
or SATA hard disk for internal
storage devices. The current
SATAII interface allows up to
3.0 Gb/s data transfer rate.
These two Serial ATA3
(SATA3) connectors support
SATA3_2
SATA3_1
SATA data cables for internal
storage devices. The current
SATA3 interface allows up to
6.0 Gb/s data transfer rate.
Either end of the SATA data cable
can be connected to the SATAII /
SATA3 hard disk or the SATAII /
SATA3 connector on this
motherboard.
880GMH/U3S3
Motherboard
connect the black end
to the IDE devices

Publicidad

loading