Aux In Mode - Lenco MC-013 Manual Del Usuario

PROGRAMMED PLAY MODE
In programmed play mode, you can program the play order of the tracks on your CD� You can program
up to 20 tracks in total�
Note: To set up programmed play mode, the CD must be stopped in the CD compartment and must not
be paused or playing�
In CD mode, with the CD you wish to programme in the CD compartment and stopped:
1� If the CD is playing press to stop
2� Press and release the 'Prog' button, 'P01' is displayed�
3� Use the Tune
or
first. Press and release the 'Prog' button to confirm.'
4� P02' will now be displayed and you can select the second track that you would like to programme�
Continue to select each track as in Steps 2 and 3 above, up to a total of 20 tracks�
5� Press "Play" to start playing programed tracks�
Note: In programmed play mode the icon will be displayed�
To exit programmed play mode, press stop button twice.
REPEAT/RANDOM MODE
• Repeat current track only�
Press the 'Repeat' button once, the repeat single track icon
• Repeat all tracks�
Press the 'Repeat' button a second time, the repeat all icon
• Random�
Press the 'Repeat' button a third time, the RAND icon will be displayed�
• Cancel repeat�
Press the 'Repeat' button a fourth time to switch off repeat mode�

AUX IN MODE

Check that your Micro is in Aux in mode. If you are not already in Aux in mode, briefly press and release
the 'Mode' button until you are in Aux in mode (check the display)�
Using a 3�5mm audio input connection cable (not included), Aux in allows for a quick and easy
connection to an external sound source�
Connect one end of the 3�5mm audio connection cable to the headphone (or auxiliary out) socket of
your secondary device, connect the other end to the auxiliary socket on the back of your Micro� Press
the 'Play' button on your external device to start playback through the Micro speakers. To gain optimal
volume levels, adjust the output volume level on both the secondary device and on the Micro� Note: It is
recommended that you unplug the Audio cable from the Line in socket after you have finished listening to
your external device�
/ �
Tune buttons to go to the track number that you would like to program to play
will be displayed�
will be displayed�
9