Axis Camera Management - Multiple Cameras/Large Installations - Axis 231D+ Guia De Instalacion

AXIS 231D+/232D+ Installation Guide

AXIS Camera Management - multiple cameras/large installations

AXIS Camera Management can automatically discover multiple Axis devices, show connection status, manage
firmware upgrades and set IP addresses.
Automatic discovery
1. Check that the camera is connected to the network and that power has been applied.
2. Start AXIS Camera Management. When the AXIS 231D+/232D+ appears in the window, double-click it to
open the camera's home page.
3. See Setting the Password, on page 11 for instructions on how to set the password.
Assign an IP address in a single device
1. Check that the AXIS 231D+/232D+ is connected to the network and that power
has been applied.
2. Start AXIS Camera Management. When the AXIS 231D+/232D+ appears in the
window, double-click it to open the camera's home page.
3. See Setting the Password, on page 11 for further instructions.
Assign IP addresses in multiple devices
AXIS Camera Management speeds up the process of assigning IP addresses in multiple
devices by suggesting available IP addresses from a specified range.
1. Select the devices you wish to configure (different models can be selected) and
click the Assign IP button.
2. Select Assign the following IP address range and enter the range of IP
addresses, the subnet mask and default router the devices will use.
3. Click the OK button.
Page 9