Additional Functions; Troubleshooting Guide; After Each Use - Guardian Technologies SPA210 Instrucciones De Uso Y Cuidado

SPA260
1. Power: Touch the Power Button
2. Clock Display: Press and hold the "Timer" Button
clock (the clock display will blink.) Touch the "Light" Button
Button to set the Hours.
Note: Repeatedly press to scroll through the Minutes/Hours when setting the time. Clock will blink then beep
once set.
3. Alarm Clock: Press and hold the "Alarm" Button
display will blink). Touch the "Light" Button
the Hours.
Note: Repeatedly press to scroll through the Minutes/Hours when setting the alarm. When the time you set
for the alarm arrives, the device will sound for 60 seconds unless you de-activate by pressing any button. The
device and light will also turn on unless there is no water. If you do not de-activate, the alarm will sound each
day at that set time. Alarm is set when light is on. To turn off, press the alarm button. Make sure tab on back
of unit is removed/discarded. This will allow clock to continue to operate when unit is unplugged.
4. Light: Touch the "Light" Button
the alarm button. Touch repeatedly to select to color. Color order is: auto color changing, red green, or blue.
Final touch will turn off the light.
5. Timer: Touch the "Timer" Button
select time of: 30, 60, 120 or 180 minutes. Final touch will turn off the timer.
6. Auto Shut Off: When the unit water level is too low, it will automatically shut off.

AFTER EACH USE

1. Turn the device OFF and unplug he unit from the electrical outlet. Lift off the top cover.
2. Drain and rinse the water tank thoroughly to remove any sediment and dirt. Wipe clean and dry with a clean
soft cloth or paper towel.
3. Remove water and clean the water tank after each use. If oil residue or the previous scent remains in the
tank, then deep clean by adding a mixture of 1 tsp. white vinegar and 1 tsp. water. Let solution stand for 5
minutes. Clean with a soft brush, empty and rinse thoroughly with water.
IMPORTANT: Do NOT fill with HOT water as this may cause leaking. Remove water from the tank when the diffuser is
not in use.
NOTE: IF YOU EXPERIENCE A PROBLEM DO NOT ATTEMPT TO OPEN THE MOTOR HOUSING YOURSELF.
DOING SO MAY VOID YOUR WARRANTY AND CAUSE DAMAGE TO THE DIFFUSER OR PERSONAL INJURY.
E-8

ADDITIONAL FUNCTIONS

to turn the diffuser on and off.
down until it beeps to enter the setting mode for the
to set the Minutes. Touch the "Alarm"
until it beeps to enter the setting mode (the Clock
to set the Minutes. Touch the "Alarm" Button
to select lighting mode. Alarm is set when light is on. To turn off press
to select when you want the diffuser to shut off. Touch repeatedly to

TROUBLESHOOTING GUIDE

PROBLEM
Water vapor not produced.
Air blows, but water vapor is
not produced.
Unit has stopped working.
Water is accumulating outside
of unit or area surrounding
unit.
Increased noise level.
to set
Water vapor, but no scent.
Aromatherapy essential oils can be purchased at
www.guardiantechnologies.com
SOLUTION
Power Plug: Unplug and then try again.
Power Failure: When the power is returned, try
again.
Excessive Water: Remove a certain amount of
water from the tank.
No or low water. Unplug unit and refill tank.
Unit not level and water is accumulating. Unplug
and place on level surface. Raise unit on a water-
resistant level surface 2-3 feet off of floor.
Unit must be placed on a flat, level, hard surface.
Make sure it is NOT placed on a soft or absorbent
surface.
Add more drops of oil mid-cycle.
E-9