Getting Started; Tools Needed - Perlesmith PSCMF1 Manual De Usuario

Getting Started

WARNING! SEVERE PERSONAL INJURY AND PROPERTY DAMAGE CAN RESULT FROM IMPROPER
INSTALLATION OR ASSEMBLY. READ THE FOLLOWING WARNINGS BEFORE BEGINNING.
If you do not understand the instructions or have any concerns or questions, please contact a
qualified installer.
Do not install or assemble if the product or hardware is damaged or missing. Not all parts and
hardware included must be used. If you require replacement parts, contact customer service at
supportus@perlesmith.com
This product has been designed for use on a vertical inner corner wall constructed of wood studs,
or concrete, or brick.Wood studs being defined as a wall consisting of a minimum of 2" x 4" studs
with a maximum of 1/2" of wall covering (drywall, lath, plaster).
This product may contain moving parts. Use with caution.
Please check www.perlesmith.com for more products and company information.

Tools Needed

Stud
Finder
Level
(included
inside the box)
P1
Tape
Pencil
measure
1/2 in.
Drill
(12.7 mm)
7/32 in.
(5.5 mm)
Wood Drill
Screw
driver
3/8 in.
(10 mm)
Concrete Drill
Hammer