Publicidad
7.
Connect HDMI cable to HDMI output on the HDMI, VGA, and Audio to HDMI
Converter Switch and then to the HDMI input on the Wireless A/V system TX.
Use HDMI cable included with the Wireless A/V system.
8.
Attach the 6ft Ultra Flexible High Speed HDMI Cable, 6ft VGA Monitor Cable
and 6ft 3.5mm Stereo Audio Cable to the HDMI, VGA, and Audio to HDMI
Converter Switch.
9.
Reference Installation Instructions, Step 5, for Wiremold A/V Table Boxes. This step
will require Phillips Screw Driver. Feed device box power cord through the right
side opening in the device plate (opening with four screw holes). Attach
power supply to device plate using (4) #4-40 screws.
10. Plug the 2 Port USB Wall Charger into AC outlet facing under table in the A/V
Table Box.
11. Connect power to the Wireless A/V system TX by using the included USB-A to
Micro-B cable. Connect USB-A to the 2 Port USB Wall Charger and connect
Micro-B to the Wireless A/V System TX.
12. Connect power to the HDMI, VGA, and Audio to HDMI Converter Switch by
using the included barrel power to USB-A cable. Connect USB-A to the 2 Port
USB Wall Charger and connect barrel power connector to the HDMI, VGA, and
Audio to HDMI Converter Switch.
Tech Tip: Remember to route the power wire as to not interfere with cabling,
especially the HDMI, VGA and 3.5mm cables fed through the grommets.
13. Reference Installation Instructions, Step 3, for Wiremold A/V Table Boxes. This step
will require Drill and Jigsaw. Install A/V Table Box using the provided table box
installation template.
a.
Cut a 6 7/16" x 5 ½" (164mm x 140mm) opening using the template
provided.
14.
Install A/V Table Box into opening in table.
15. Reference Installation Instructions, Step 4, for Wiremold A/V Table Boxes. Place
mounting brackets into slots on sides of A/V Table Box. Tighten thumb
screws against the bottom of the table.
16. Reference Installation Instructions, Step 7, for Wiremold A/V Table Boxes. Snap
faceplate onto device plate to finish installation. (In order to insert the
faceplate into the box, the cover must be lifted up slightly).
17. Connect power cord for A/V Table Box power bank to AC outlet.
18. Attach Wireless A/V system RX to display using the included adhesive pad.
RX may be attached to wall/display or mount.
Publicidad
