Using The Aux Input - AR AWSBT10 Instrucciones

Using the AUX input

Use the audio cable included with this speaker to
connect the audio output from your device to the
Aux In audio input on the speaker's back panel (you
might need to open the rubber flap protecting the
jack). The speaker automatically switches to the
Aux In audio. The Status light on the front of the
speaker turns white if you're using a single speaker.
It turns blue if you're using two in stereo mode.
To listen to Bluetooth audio again, unplug the cable
from the speaker's Aux In jack.
Recharging the speaker
The speaker's built-in rechargeable battery comes from the factory with a
charge, so you can start using the speaker as soon as you get it out of the box.
After you've used it for a while, you'll need to recharge the speaker's battery.
To recharge the speaker: Plug the included AC cable into the DC In jack on the
back of the speaker.
Plug the other end of the adapter into a power
outlet.
The Battery indicator on the front of the speaker
is red while the speaker is charging. It turns green
when the speaker is fully charged.
Note: You can use the speaker while it's charging.
Speaker back
Speaker back
7