Sony Ericsson HBH-35 Manual Del Usuario página 11

Using voice commands
Voice commands are especially useful when you are
using the headset. For information on voice commands,
refer to the phone's user documentation.
Adjusting the speaker volume
You can adjust the headset speaker volume during a call.
To adjust the speaker volume
• To increase the volume, press
• To decrease the volume, press
Adjusting the ring volume
You can adjust the headset ring volume when you are
not engaged in a call.
To adjust the ring volume
• To increase the ring volume, press
• To decrease the ring volume, press
Note: The headset uses increasing volume. For safety
reasons, it starts with a low volume level before the
maximum set level is reached.
This is the Internet version of the user's guide. © Print only for private use.
Transferring sound from phone to headset
If you make a call without using the headset, you can
transfer the sound to the headset if the headset is on,
paired with the phone and within range.
To transfer the sound to the headset
• During a call, press and hold
to the headset. The headset beeps until the sound has
been transferred.
.
. If the headset is turned on after a call has been initiated,
you can transfer the sound to the headset by pressing
and holding
Note: To transfer the sound from the headset to the
phone refer to the phone's user documentation.
. Lost connection to headset
. If the connection to the headset is lost during an
ongoing call, move back within range of the phone and
then press
not, the call is disconnected after 30 seconds.
to transfer the sound
.
to resume the conversation. If you do
Using the headset 11