Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
•
Only use the device for its intended purpose. All other uses may lead to
short circuits, burns, electroshocks, lamp explosion, crash, etc. Using
the device in an unauthorised way will void the warranty.
•
Damage caused by disregard of certain guidelines in this manual is not
covered by the warranty and the dealer will not accept responsibility for
any ensuing defects or problems.
•
Mechanical wear is not covered by warranty.
•
Lighting effects are not designed for permanent operation: regular
operation breaks will prolong their lives.
4. Overview
Refer to the illustrations on page 2 of this manual.
1
microphone
2
laser aperture
3
motor controller
4
mode select button
5. Operation
Refer to the illustrations on page 2 of this manual.
Installation
•
Install the device in the desired location. Either hang it by the mounting
bracket or place it on the included stand (screw the stand in the bottom
of the device).
Switch on
•
Plug the dc plug from the included mains adaptor in the 5Vdc input.
•
Make sure the device is switched off ([7] + safety key, see picture on
first page) and plug the mains adaptor into a suitable mains outlet.
Effects
•
Turn the safety key and switch the device on by setting the function
switch [7] to the middle position for normal operation, or completely to
the left for strobe effect.
•
Use the mode select button [4] to choose between automatic mode or
sound controlled mode.
•
To change the speed of the moving lights in auto mode, turn the motor
controller [3].
Switch off
•
When the strobe effect is selected, change the strobe speed with the
strobe speed controller [6].
•
Switch off the device with the function switch [7] and the safety key.
V. 03 – 12/11/2013
VDL150RGML
5
cooling fan
6
strobo speed control
7
function switch
8
5 Vdc input
5
©Velleman nv
Publicidad
Tabla de contenido
