CLIMASTAR OPTIPLUS 1600 Manual De Instrucciones página 6

1. GENERAL INFORMATION
2. DESCRIPTION / OUTWARD APPEARANCE
3. BEFORE STARTING YOUR DEVICE
4. ASSEMBLY
5. SETTING UP
6. RECOMMENDATIONS OF USE
7. TECHNICAL DATA
8. FAQs
9. GUARANTEE
1.GENERAL INFORMATION
- Climastar Heating System must only be destined for heating.
- A proper design and insulation of the room will ensure that the system provides enough heat for your entire satisfaction.
- The household installation must be under the electro technical low voltage regulation.
- All our devices have an automatic turn off system that works in case of overheating. The device will automatically switch off its work
if it is overheated. When the cause that produced the overheating ceases the device will automatically start functioning again after a
few minutes. If this situation is repeated without the grids being covered or obstructed, please contact the Technical Service.
- The device does not need an earth wire because it is a Class II device (electrically isolated).
- When the device is on its surface remains hot. For security reasons children must be kept away from the radiator.
- Do not cover totally or partially the radiator. Do not place any kind of material, cloths, towels, plastics,...that may limit the air flow in
the upper part of the heater.
- Press the buttons softly to avoid any damage; do not manipulate the device with ball pens or similar to avoid scratches
2.DESCRIPTION / OUTWARD APPEARANCE
Wheels
LIST OF COMPONENTS
Be sure the following elements are included. If any is missing, please contact your distributor:
1x
3.BEFORE STARTING YOUR DEVICE
- Make sure the supply voltage corresponds with that on the nameplate
- Verify that the system's or other connection wires are not in contact with the device's surface.
- If the radiator is located in the kitchen or bathroom/shower, make sure it is placed in such a way that someone in touch with water
cannot activate the controls, in compliance with the regulation in force in each country.
- The heating systems cannot be installed in a location with a high risk of explosion or fire. Example: fuel, oil or gas warehouses, etc...
4.ASSEMBLY
Screw the wheels as shown below:
INDEX
Plug
2x
Display
Handle
Switch
4x 4x
6